Buying a used twin-turbo sports sedan with more than 170,000 km always brings a mix of excitement and second-guessing. A 2016 Infiniti Q50S 3.0T at 171,000 km (about 105,000 miles) for CAD $9,500 — roughly USD $6,900 — sounds like a tempting number on paper. The question is whether the price holds up once you account for the car's condition, the documented maintenance history, and the CAD $800–$1,200 worth of work still needed to make it street-legal.
The deal at a glance
- Vehicle: 2016 Infiniti Q50S, 3.0L VR30 twin-turbo V6, completely stock
- Mileage: 171,000 km (approximately 105,000–106,000 miles)
- Price paid: CAD $9,500 (about USD $6,900), excluding repairs and taxes
- History: Good maintenance record; one insurance claim for a minor front-bumper scratch, since repaired
- Underbody: Rust-protected by the previous owner, minimal surface rust
For the money, the buyer got a clean-interior, unmodified example of the 3.0L twin-turbo Q50 — the trim that pairs the VR30 with sport-tuned suspension and stronger brakes. No warning lights are showing, the engine idles and accelerates cleanly, and there are no reported engine, transmission, or exhaust leaks. Those are all encouraging signs for a high-mileage platform.
Maintenance already completed
Before driving the car much, the buyer performed a sensible tune-up that addresses the most common wear items on a car of this age:
- Spark plugs replaced
- Cabin air filter and engine air filter replaced
- Engine oil changed
- All four brake rotors and pads replaced
- MAF sensor cleaned to improve idle behavior
This is exactly the kind of baseline service a high-mileage turbo car needs, and it suggests the seller's own notes about the brakes being "gone" were either written before this service or refer to an item that deserves a re-check. Either way, it's worth confirming exactly what is on the car now before paying a shop to redo the same work.
What still needs attention
Front-end clunk
The buyer reports a clunk from the front suspension, with ball joints or outer tie rod ends as the likely culprits, and a diagnosis is pending. On the Q50, this kind of noise is frequently traced to worn control-arm ball joints, tie rod ends, or stabilizer links. A proper inspection should identify the source before replacement — and it's one of the more common, moderately priced repairs on this chassis.
HVAC temperature split
The air conditioning blows very cold, but only on the passenger side. This one-sided temperature issue is a well-known Q50 complaint, usually caused by a failing blend door (air mix) actuator. The buyer has already ordered the replacement actuator, which is the typical fix and a relatively inexpensive job.
Body, paint, and lighting
Minor surface rust is forming on the rear fender above the tire, and there are a few scratches plus a small door ding. None of this is mechanical, but the fender rust is worth treating early before it spreads. The hazy headlights can be restored or replaced — restoration is the budget-friendly option and will also improve nighttime visibility.
Adding up the safety inspection, the front-end diagnosis and repair, the HVAC actuator, and the cosmetic items, the buyer's CAD $800–$1,200 estimate is realistic — and in the best case it may land at the lower end if the clunk turns out to be a single worn link.
How the VR30 engine behaves at this mileage
The VR30DDTT is a powerful and generally robust engine, but it is a modern twin-turbo with known talking points. Owner communities report that some cars have experienced turbocharger wear (including wastegate-linkage rattles), coolant consumption in certain cases, and accessory-belt-related issues. None of these are universal, and a strong maintenance record plus a stock, unmodified car go a long way toward reducing the risk. The fact that this example is untouched is a genuine positive — modified twin-turbo cars are far harder to evaluate.
For peace of mind at this mileage, a compression test, a look at coolant levels and oil condition, and a close listen to the turbos at cold start are inexpensive checks that can catch a developing problem before it becomes a four-figure bill.
Market check: what 2016 Q50 3.0t models sell for
On the Canadian used market, 2016 Q50 3.0t examples routinely list in the CAD $14,000–$21,000+ range depending on trim and condition, with sport-trimmed 3.0t models averaging well above CAD $15,000. At CAD $9,500, this car was bought for a meaningful discount to typical asking prices, and even with CAD $1,200 of repairs the all-in cost stays near CAD $10,700 — still comfortably below where most comparable 3.0t Q50s are advertised.
The verdict: overpaid or a smart buy?
Based on the price paid, the condition described, and the remaining repair estimate, this does not look like an overpayment. The buyer acquired a clean, unmodified twin-turbo sedan with documentation, a rust-protected underbody, and a recently refreshed maintenance baseline for well under typical market value. The main risk on a car like this is never the sticker price — it is deferred maintenance on a turbocharged powertrain. If the pending front-end diagnosis stays within the expected budget and the VR30 checks out on compression and turbo health, the total investment remains attractive.
Bottom line: At CAD $9,500 with roughly CAD $800–$1,200 of work ahead, this 2016 Q50S 3.0T shapes up as a fair-to-strong deal — provided the inspection confirms no hidden engine or turbo trouble. The smartest next step is to finish the suspension diagnosis and get a pre-purchase-style mechanical inspection, then enjoy a fast, comfortable sedan at a price that beats the market.