Dr. DWC
10/11/2026
Verified buyer
I service European cars at an independent repair garage and see many Mercedes 4MATIC sedans come in forsuspension and drivetrain repairs. A customer brought in a 2010 Mercedes C300 4MATIC with clicking sounds from the front left wheel during sharp turns and grease flung across the inner wheel well from a split boot. I ordered this PHILTOP front CV axle shaft pair, parts 66-9306 and 66-9307, to replace both front axles.The installation on the W204 4MATIC chassis went smoothly. The overall length, spline count, and seal diameters match the original Mercedes half-shafts accurately. The inner joints locked cleanly into the front differential and intermediate housing, while the outer splines slid into the front wheel hubs without binding. The supplied spindle collar nuts threaded on and torqued to specification without stripping.The build quality appears dependable. The boots are made from thick neoprene that flexes smoothly without pinching, and the crimped metal clamps keep the synthetic grease sealed inside. The CV joints articulate freely by hand with no binding or excessive slop.On the road test, the clicking noises were completely eliminated. The car accelerates smoothly from a standstill, and highway cruising at seventy miles per hour is quiet and vibration-free. These axles offer a reliable, cost-effective alternative to expensive genuine parts for maintaining 4MATIC all-wheel-drive vehicles.




