Mr Chris
08/21/2026
Verified buyer
99 S10 2.2 works fits good

Leak-Tested
Durable
Check if this fits your vehicle
Select a vehicle to check this product.
Check if this fits your vehicle
| Year | 1997 - 2000 | 1997 - 2002 |
|---|---|---|
| Make | Jeep | Jeep |
| Model | Cherokee | Wrangler |
| Trim | SE | SE |
| Engine | 2.5L L4 | 2.5L L4 |
| Note | For warranty purposes it is recommended to always install a filter and to use suggested OE Fluid and flush the system;In-Line Filter available;Reservoir Not Included | For warranty purposes it is recommended to always install a filter and to use suggested OE Fluid and flush the system;In-Line Filter available;Reservoir Not Included |
Codes alone do not confirm power steering pump failure. Definitions and diagnostic procedures vary by vehicle.



4.9/5
Based on 8 reviews
Mr Chris
08/21/2026
Verified buyer
99 S10 2.2 works fits good
Dr. J
09/21/2026
Verified buyer
I took my 97 TJ 2.5L into the shop for an assessment and one of their findings was that the PS pump was leaking. It wasn't leaking much (the fluid level was steady, no noise, etc) but they wanted nearly $800 to replace it. This pump was ~ $100, the pulley puller was $20 from HF, and a jug of PS fluid was about $10. Fortunately the TJ is very easy to work on and the pump is right at the top. The most difficult part was using the puller to force the old pulley on the new unit and judging how far to push it on, but I used the shaft of the old pump as a guide (there was a witness mark on the shaft showing what had been exposed) and it seems to work fine [if you don't have the pulley positioned correctly it could cause premature wear to the belt and/or noise]. The 2 OE hoses worked fine including the high pressure side which has the small O-ring and mine looked a bit suspicious.I don't drive the vehicle a lot but it's not leaking, not making noise.
1. The long storage time causes the vanes to be stuck by oil: Check for oil fluctuations in oil tank. 2. Faults of tie rods, ball cages, tires, steering gear: Check the relevant parts
1.Power steering fluid low: Check oil tank level. 2. Air in the boost system: Check the oil for air bubbles. 3. Aging pipes and clip: Check the aging of low pressure pipe. 4. Rotational system issues: Check associated axle clearance except crankshaft
Installed or modified products may require additional review and may not qualify for a standard return. Please contact Philtop before removing or returning the product.
Loading vehicle options...
Choose Year, Make, and Model to check exact fitment.
Leak-Tested
Durable
Check if this fits your vehicle
Select a vehicle to check this product.
8 reviews
5 star: 7
4 star: 1
Check if this fits your vehicle
| Year | Make | Model | Trim | Engine | Notes |
|---|---|---|---|---|---|
| 1997 - 2000 | Jeep | Cherokee | SE | 2.5L L4 | For warranty purposes it is recommended to always install a filter and to use suggested OE Fluid and flush the system;In-Line Filter available;Reservoir Not Included |
| 1997 - 2002 | Jeep | Wrangler | SE | 2.5L L4 | For warranty purposes it is recommended to always install a filter and to use suggested OE Fluid and flush the system;In-Line Filter available;Reservoir Not Included |
Codes alone do not confirm power steering pump failure. Definitions and diagnostic procedures vary by vehicle.



4.9/5
Based on 8 reviews
Mr Chris
Aug 21,2026
Verified buyer
99 S10 2.2 works fits good
Dr. J
Sep 21,2026
Verified buyer
I took my 97 TJ 2.5L into the shop for an assessment and one of their findings was that the PS pump was leaking. It wasn't leaking much (the fluid level was steady, no noise, etc) but they wanted nearly $800 to replace it. This pump was ~ $100, the pulley puller was $20 from HF, and a jug of PS fluid was about $10. Fortunately the TJ is very easy to work on and the pump is right at the top. The most difficult part was using the puller to force the old pulley on the new unit and judging how far to push it on, but I used the shaft of the old pump as a guide (there was a witness mark on the shaft showing what had been exposed) and it seems to work fine [if you don't have the pulley positioned correctly it could cause premature wear to the belt and/or noise]. The 2 OE hoses worked fine including the high pressure side which has the small O-ring and mine looked a bit suspicious.I don't drive the vehicle a lot but it's not leaking, not making noise.
1. The long storage time causes the vanes to be stuck by oil: Check for oil fluctuations in oil tank. 2. Faults of tie rods, ball cages, tires, steering gear: Check the relevant parts
1.Power steering fluid low: Check oil tank level. 2. Air in the boost system: Check the oil for air bubbles. 3. Aging pipes and clip: Check the aging of low pressure pipe. 4. Rotational system issues: Check associated axle clearance except crankshaft
Installed or modified products may require additional review and may not qualify for a standard return. Please contact Philtop before removing or returning the product.