The Apex Hunter’s Guide: A DIY Diagnostic Guide to the Scion FR-S (2013–2016)
The Scion FR-S is a pure enthusiast’s car. While the Scion brand was eventually absorbed back into Toyota (relabeling the car as the 86), the FR-S remains the quintessential "86" experience in North America. Born from a partnership between Toyota and Subaru, it features the FA20 Boxer engine.
Because the FR-S only existed for a few years (2013–2016), it represents the early phase of the "ZN6" platform. If you’re wrenching on one in 2026, you need to know the difference between a "first-year" design flaw and standard mechanical aging.
1. Generation Context
- 2013–2014: The early adopters. These models faced the most "teething" issues from the factory.
- 2015–2016: Refined suspension tuning and the introduction of improved interior materials and updated bolt-on components.
2. Common Failures: Design Flaws vs. Aging
Design Flaws (The "Factory Quirks")
- Valve Spring Recall (2013 Models): The most famous FR-S issue. Early 2013 engines had valve springs prone to fracturing, which could lead to total engine failure.
- Cam Plate Oil Leak: The rear of the passenger-side cylinder head has a block-off plate for a vacuum pump (used in other markets). The factory seal is notorious for leaking oil onto the hot exhaust.
- The "Cricket" Noise: High-pressure fuel pumps (HPFP) on these cars are famous for a high-pitched chirping sound. It is generally harmless but annoying.
- Condensation in Taillights: The factory gaskets were poorly designed, allowing water to pool inside the light housings.
Aging Issues (Wear & Tear)
- Front Timing Cover Seepage: The RTV sealant used by the factory begins to "weep" oil after 80,000 miles.
- Throw-out Bearing (TOB) Failure: In manual models, the TOB often begins to squeak or grind after 60,000 miles, eventually leading to clutch failure.
- Torn Shifter Boot/Seal: The rubber insulator at the base of the shifter cracks, letting transmission heat and noise into the cabin.
3. The DIY Diagnostic Checklist
👂 LISTEN (The Ears)
- A High-Pitched "Cricket" Chirp at Idle:
- Diagnosis: Normal High-Pressure Fuel Pump operation. It usually gets louder with low-quality or ethanol-heavy fuel.
- A "Whirring" or Squealing when the Clutch is Pressed:
- Diagnosis: Failing Throw-out Bearing. If the noise stops when you release the pedal, the bearing is dry and needs replacement.
- A "Clicking" or Metallic Pop when Turning the Wheel:
- Diagnosis: Likely a failing Electric Power Steering (EPS) coupler inside the steering column.
👀 SEE (The Eyes)
- Oil on the Passenger-Side Exhaust/Overpipe:
- Diagnosis: Leaking Cam Plate. Look behind the engine on the passenger side for black, crusty oil residue.
- Foggy or Water-Filled Taillights:
- Diagnosis: Failed Taillight Gaskets. Check after a car wash or heavy rain.
- Check Engine Light + "Traction Control Off" Light:
- Diagnosis: Often caused by a Dirty MAF Sensor or a failing VVT Solenoid (Variable Valve Timing).
👃 SMELL (The Nose)
- Burning Oil after a Spirited Drive:
- Diagnosis: Again, check the Cam Plate or the Timing Cover. Oil is likely dripping onto the hot exhaust manifold.
- A "Sweet" Syrup Smell:
- Diagnosis: Check the Coolant Expansion Tank. The plastic tanks are known to crack near the mounting points as they age.
✋ TOUCH (The Hands)
- Vibration in the Gear Shifter at High RPM:
- Diagnosis: Normal for this car's direct-linkage shifter, but if it's excessive, check the Transmission Mount.
- "Notchy" Shifting when Cold:
- Diagnosis: The Aisin 6-speed manual is picky about fluid. If it feels like it’s "crunching" into 2nd gear, it’s time for a Fluid Flush with high-quality synthetic gear oil.
💻 TOOLS (The Tech)
- OBD-II Scanner: Look for code P0016, P0017, P0018, or P0019.
- Diagnosis: These are the "Cam/Crank Correlation" codes. In early FR-S models, this often points to a failing VVTi Actuator or Solenoid.
- Multimeter: Test the battery. The FR-S has a relatively small battery; low voltage will cause "phantom" power steering errors.
- Torque Wrench: Check your Lug Nuts and Strut Tower Bolts. The FR-S is a stiff car, and vibrations can loosen suspension hardware over years of track/canyon use.
Summary: The FR-S Owner’s Cheat Sheet
Feature | 2013–2014 (Early) | 2015–2016 (Late) |
|---|---|---|
Main Engine Concern | Valve Springs / Cam Plate | Timing Cover Seepage |
Common Nuisance | Taillight Condensation | "Cricket" Fuel Pump |
Drivetrain Risk | Throw-out Bearing | Throw-out Bearing |
Essential Tool | OBD-II Scanner | 14mm Socket (Cam Plate) |
The Golden Rule for FR-S Owners
Check Your Oil Weekly: The FA20 engine has a relatively small oil capacity (approx. 5.4L). Because these cars are often driven "enthusiastically," they can consume oil at high RPMs. Running just 1 quart low during a high-G corner can cause oil starvation and a spun rod bearing.
Keep it topped up, fix that cam plate leak, and your FR-S will remain one of the best-handling machines on the road!