22026-02-15

The pipe fits well and is of good quality other than the fact that the junction where you clamp the two separate pieces together does NOT seal with the provided hardware. As a results the front piece of the pipe can fall out of the rear piece while driving. I took mine off and had it welded together which costs extra money. Hardware supplied is adequate.

22025-07-26

Well it fit ok bolting up to head and exhaust pipe and the other brackets that bolted to block. But the tabs for the heat shields were way off. Had to do a lot of rigging to make heat shields work. Just hope the converter part is as good as they say.

22025-09-19

These call converter are bad for my car code P0420 saying blank 1& 2 are bad

22024-10-26

Well the passenger side catalytic converter mounted and sealed to the manifold and muffler perfectly, but all that did was set me up for the utter headache that followed with the resonator and drivers side catalytic convertor. After connecting the resonator to the passenger side cat i started realizing some things might be off as only one of the two exhaust hangers reached its anchor point. So pipe angle is definitely off. Next was the drivers side catalytic converter after bolting it down as far as it would go, there was still a massive gap between the top of the catalytic converter pipe and the exhaust manifold i can literally put my finger completely through the gap, which is ridiculous, but then trying to get that catalytic converter to line up with other end of the resonator was a nightmare. Either way I'm still not even sure if my catalytic convertor actually work yet as I will have to Frankenstein this system in order to get it to work. Hopefully they do, because I don't need anymore migraines from this. Read more

22025-09-29

Tried to mount mine on my Jeep XJ. It looked just like my previous cat but the flange holes do not line up with the factory flange. I could fight to get three of the four holes bolted but there was no way to get the third as it was at least an eighth of an inch (3mm) off. Can't speak to any other features or performance. It does look good and well made if the holes lined up.

22025-11-20

Bad angle did not line up correctly.Had to modify

22026-02-10

They fit in pretty good on my 2014 Silverado, but be aware, the clamps they send are not worthy whatsoever. I’ve adjusted the clamp 20 times and still have a really bad exhaust leak, i’m having to have it welded. Before installing not a single problem with my truck, now after install, i have to replace the O2 sensors because first crank, the check engine light is on. overall it’s good i guess for the price, but it’s going to come with issues.

22025-06-23

I’m not sure what happened but one of these had the wrong flashing on the end of it and it did not fit our 2012 Honda odyssey. So be sure to check that before you start putting these on!

22026-03-12

After two weeks of having them on my 08 Silverado the drivers side started rattling again… not sure if I got a bad one or if there all bad but do yourself a favor and spend the extra money..

22026-08-12

FIt my Subaru but the check engine light is still on for catalytic converter. It fit I had to adject the angle a little but I think it was because my exhaust pipes are a bit rusty. Just a side note it doesnt make your car sound different kind of like a speaker inside a aluminum can.