52025-01-21

I purchased these for my 1997 Jeep Cherokee XJ. I run a high pinion Dana 30 and a Chrysler 8.25 rear. Stock I have 3/4” of stud showing on both axles. I was able to get about 7/16” of the new nut over the stud with spacer in place. I wish it was more but I think they will work. Haven’t run them on the car yet. My old Dana 35 axle also shows 3/4” stud so it should work on that axle too.

52025-04-08

Everything going well low mileage

52025-01-14

good

52025-04-17

As advertised, no problems.

52025-01-16

Perfect for adding lay model rims to my old keep. Great product!

52025-05-20

Product is of good quality, shipped quickly and was reasonably priced!!!

52025-05-06

Seems to be a good product

52025-01-07

I am using these to check fitment, with a caliper they measure out to 7.8mm.

52025-03-19

Did what i was looking for. Just have to make sure u have enough room behind the lug to use it.

52025-02-12

Perfect fit for my Mustang. Just enough to allow a 10.5 wheel on the front with no rubbing. No balance issues after install.