Customer Reviews

Read product reviews from across PHILTOP.

Make
Category
Rating
Sort By

4.7/5

Based on 60,823 reviews

577%
417%
36%
20%
10%

Customer photos and videos

All product reviews

Reviews per page

60,823 reviews

4.0

Cost effective replacement for a worn-out cat

  • Good quality
  • Easy install
  • Good price
BrandonVerified buyer

Our 2003 CR-V at 250K miles has been throwing P0420 codes intermittently for about a year. P0420 indicates catalytic convertor is not operating efficiently; in our case, it's 22 years old and has a quarter million miles, so it's just tired.This convertor is a bit smaller diameter than the OEM convertor but has a similar heft. The inclusion of new hardware and gaskets is a nice touch as there's no way that crusty, heat cycled fasteners can be effectively reused.Installation was relatively quick (five bolts and an O2 sensor) and took about an hour of leisurely wrenching on ramps. Fit was accurate and did not require bending, bashing, or fabbing. There was more than enough slack in the exhaust hangers to make up the 1/16 to 1/8" difference. Since it's a bolt in unit, it may not be the answer if thieves cut out your catalytic converter beyond the flanges.I've cleared the codes and have noticed no leaks, unusual smells, nor degradation of performance. The P0420 has not popped again, indicating that it's doing its job. For under $100, this is a very quick way of replacing an end-of-life cat to make a vehicle sellable or pass OBD2 scan emissions if your area requires them.Good value.

4.0
  • Good quality
  • Good price
Doug WomackVerified buyer

Very high quality. Suprising for the price. All 4 were perfectly uniform, studs were premounted which Is very nice. No trimming of studs required. Running 305/30r19 Ventus V12s in the rear on stock Nismo Ray's. Lowering the car tomorrow. A lot of poke but I flexed on a curb to check clearance. Looks like less than 1mm if it even clears when bottomed out. Great product very inexpensive compared to name brands that are identical. Drove fine, felt extra planted.

5.0
  • Easy install
BrandonVerified buyer

Bought these for my 2011 ram 1500 quad cab slt. They went on percent and very easy but I do want to say one thing, instead of shaving down your studs, just go to your local parts store and buy the 1/4 in spacers and put those on behind the 1 1/2 spacers and you WILL NOT have to grind or modify your studs. Best of luck, I would buy again.

5.0

Great set

  • Good packaging
  • Good quality
Lisa YVerified buyer

Nice gasket set for my 2002 cavalier. Has all the gaskets that you would need in a convenient set. Everything comes nicely packaged in individual plastic bags. Even comes with a tube of hi-temp silicone. Comes with all the head gaskets and head bolts you need to redo a top end gasket rebuild. Everything is made solid and well equal to any oem parts I’ve used in the past.

5.0

Everything you need

  • Good quality
Straight TalkerVerified buyer

This kit came with everything I needed to maintenance the timing set on my '03 Civic. Don't remove the pin from the tensioner until you have the belt in place!!!It is always best to install a new water pump and camshaft seals when replacing the timing belt on a Honda. This kit has the water pump & gasket, valve cover gasket, cam seals, front crank seal, timing belt and timing belt tensioner.

51701–51720 of 60,823 reviews