Customer Reviews

Read product reviews from across PHILTOP.

Make
Category
Rating
Sort By

4.7/5

Based on 60,823 reviews

577%
417%
36%
20%
10%

Customer photos and videos

All product reviews

Reviews per page

60,823 reviews

5.0

Suitable replacement for Rav4

  • Perfect fit
  • Good quality
  • Easy install
CharlieCharlieVerified buyer

These filters fit our 2018 Rav4. The material and build quality feels very close to the oem filters I am replacing. I like that the cabin filter shows the direction to install it; the air flow goes one direction. The engine air filter drops in to the stock air box and seats like the original. Install for both is very simple and only takes a couple minutes. This is a decent set of filters to consider for daily drivers, weekend trip vehicles and really anything other than extreme offroad vehicles.

5.0

Good Replacement Part (2017 Nissan Juke)

  • Works well
  • Hard to install
DanielDanielVerified buyer

Item works as described. I only needed 1 side, but it comes with 2. I have large hands and it is easy to cut your hands on the sharp metal in the door panel as well as the regulator. Especially when removing the old one. The driver side was a little more difficult, but overall was straight forward. The instructions provided worked, but below is a little more info if you need. This was for a 2017 Juke.Step 1: Remove the rear door trim panel: Use a plastic pry tool set to pry up the window switch panel and unplug it. Remove visible screws using a Phillips screwdriver. Use a trim clip removal tool to pop the panel clips free around the edges. Lift the panel straight up to unhook it from the window ledge, then unplug any remaining connectors with a small flat-blade screwdriver to release locks.Step 2: Peel back the vapor barrierStep 3: Support the glass: Add 2–4 long strips of painter's tape from the glass over the door frame to hold the glass up once it’s unclamped.Step 4: Unclamp the glass from the regulatorShine a flashlight through the door access holes to locate the glass-to-regulator clamp bolts.Use a 10mm socket loosen/remove the clamp bolts. Once loose, slide the glass fully up by hand and add painters tape.Step 5: Disconnect the regulator motor electrical connector inside the door. Press the lock tab and unplug the connector.Step 6: Remove the regulator assembly: Use a 10mm socket a to remove the regulator mounting bolts. Rotate and guide the regulator out through the largest access opening.Step 7: Install the new regulator: Feed the new regulator into the door the same way the old one came out. Start all bolts by hand first, then tighten using a 10mm socket. Reverse process of removal and use tape to hold down the vapor barrier if it will not reseal to door.

5.0

Dependable replacement

  • Perfect fit
  • Good quality
  • Good price
Jessica PierceVerified buyer

This rack and pinion assembly turned out to be a solid replacement. Fitment was spot-on for my vehicle, and everything lined up the way it should during installation. Once installed, the steering felt tight and responsive again, which made a big difference compared to the worn-out original.The build quality seems good, and there were no leaks or issues after installation. It’s a great option if you're trying to restore smooth steering without paying dealership prices.Overall, this is a dependable replacement part that gets your steering back to feeling like it should. Good value and worth considering if you're dealing with loose or noisy steering.

9621–9640 of 60,823 reviews