Customer Reviews

Read product reviews from across PHILTOP.

Make
Category
Rating
Sort By

4.7/5

Based on 60,823 reviews

577%
417%
36%
20%
10%

Customer photos and videos

All product reviews

Reviews per page

60,823 reviews

5.0

Good Replacement Part (2017 Nissan Juke)

  • Works well
  • Hard to install
Daniel and LoriVerified buyer

Item works as described. I only needed 1 side, but it comes with 2. I have large hands and it is easy to cut your hands on the sharp metal in the door panel as well as the regulator. Especially when removing the old one. The driver side was a little more difficult, but overall was straight forward. The instructions provided worked, but below is a little more info if you need. This was for a 2017 Juke. Step 1: Remove the rear door trim panel: Use a plastic pry tool set to pry up the window switch panel and unplug it. Remove visible screws using a Phillips screwdriver. Use a trim clip removal tool to pop the panel clips free around the edges. Lift the panel straight up to unhook it from the window ledge, then unplug any remaining connectors with a small flat-blade screwdriver to release locks. Step 2: Peel back the vapor barrier Step 3: Support the glass: Add 2–4 long strips of painter's tape from the glass over the door frame to hold the glass up once it’s unclamped. Step 4: Unclamp the glass from the regulator Shine a flashlight through the door access holes to locate the glass-to-regulator clamp bolts. Use a 10mm socket loosen/remove the clamp bolts. Once loose, slide the glass fully up by hand and add painters tape. Step 5: Disconnect the regulator motor electrical connector inside the door. Press the lock tab and unplug the connector. Step 6: Remove the regulator assembly: Use a 10mm socket a to remove the regulator mounting bolts. Rotate and guide the regulator out through the largest access opening. Step 7: Install the new regulator: Feed the new regulator into the door the same way the old one came out. Start all bolts by hand first, then tighten using a 10mm socket. Reverse process of removal and use tape to hold down the vapor barrier if it will not reseal to door.

9601–9620 of 60,823 reviews