32025-01-11

I would have given a higher star rating, but the seller doesn't like to respond to emails when questioned about their product, apparently the wheel studs are metric due to the stamp on the back of the stud saying "metric 10.9" which is barely equivalent to grade 5 SAE hardware, not what I would expect for a wheel stud, I would expect grade 8 studs installed, the supplied stamped 1/2-20 lug nuts fit, but feel sloppy, thank fully I used aftermarket ARP lug nuts and studs in these wheel spacers, cheap insurance but still socks when you have to chunk out over $100 to upgrade studs and nuts

32025-02-20

<span data-hook="review-body" class="a-size-base review-text review-text-content"> <span> These are nice quality spacers, but they only ship as a set of 2 not a set of 4 as advertised. </span> </span>

32025-03-14

The spacer on the left had studs that failed. This was not a product defect, but a missed step in the instructions. there is the possibility/probability that the studs from the vehicle will stick out from the spacer and contact the wheel before the wheel contacts the spacer face. If this happens, the studs will fail. If you look at the spacer on the right, the face have contact indications on it and the studs did not fail. It would be best if the vehicle studs did not stick out past the spacer face. On my wheels, the difference between the front and rear was the rear was sticking out 1/16th inch more than the front. The rear failed and the front didn't. I am seeing pictures of other failures with no wear marks on the face of the spacers. This isn't a quality issue, it's an installation issue.

32025-03-25

Not shabby, just make sure your vehicle does not need hub centric

32025-02-14

Installed the spacers today, they seem to be of good quality. I did like that lock tight was provided for instal. Was not impressed with the lug nuts or studs

32025-03-04

Good looking set of spacers but I have only attempted to install them.

32025-05-05

Mustang be aware you will need to replace the Studs.

32025-01-22

Works great! Was able to fit my 33s on my 2016 Sierra with 3 1/2” leveling kit. Didn’t rub my<br>Fenders until I put in my aftermarket Rough country upper controls arms on. Now it rubs the inside fender well a tiny bit!

22026-06-28

The cat isn't as large as the original, so you need to purchase a kit so that you can reinstall the heat shield and bracket. That would've been nice to know ahead of time.

22025-10-13

I ordered to replace for my 2003 Honda CRV. It looked good and went on smoothly. It was missing the screws for the connections, luckily I was able to reuse the originals. Unfortunately it doesn't work it cleared the my check engine light for about 300 miles then came on again this time just changing the faults to incorrect readings on O2 sensors. This may work for other peoples cars but it didnt pan out for mine.