Customer Reviews

Read product reviews from across PHILTOP.

Make
Category
Rating
Sort By

4.7/5

Based on 60,823 reviews

577%
417%
36%
20%
10%

Customer photos and videos

All product reviews

Reviews per page

60,823 reviews

5.0

good quality filter

  • Good quality
  • Perfect fit
  • Good price
JamesJamesVerified buyer

I got this third-party engine air filter for my Kia K5 2025. The quality of this filter is fairly good, and it fits perfectly in my vehicle. One of the main reasons I opted for this third-party option is the cost savings. Changing the filter at the dealer can be quite expensive, but this alternative offers great value without compromising on performance. The installation process was straightforward, and the filter has been working flawlessly. My car's engine runs smoothly, and I haven't noticed any difference compared to the original filter. highly recommended.

5.0

good quality filter

  • Good quality
  • Perfect fit
  • Good price
JamesVerified buyer

I got this third-party engine air filter for my Kia K5 2025. The quality of this filter is fairly good, and it fits perfectly in my vehicle. One of the main reasons I opted for this third-party option is the cost savings. Changing the filter at the dealer can be quite expensive, but this alternative offers great value without compromising on performance. The installation process was straightforward, and the filter has been working flawlessly. My car's engine runs smoothly, and I haven't noticed any difference compared to the original filter. highly recommended.

5.0
  • Perfect fit
  • Easy install
  • Good quality
JoshVerified buyer

I ordered these for 2010 mazdaspeed 3. Fit was perfect. As easy to install as a wheel. These are extremely well made, the tolerances were accurate, the hub centric was snug not tight but not loose like some cheaper ones. Several notes:1: make sure you do your homework on the size of spacer, I have aftermarket wheels and I knew I would have to do a little fender rolling and modifying. Measure measure measure2: your mounting surface and hub must be clean clean clean!!! I just put brand new rotors on so the rotor surface was new, I wire brushed my hubs to clean the slight surface rust.3: take your time torquing and re torquing. I did it in several steps, first install and torque the spacers to 100 ft lbs. Then install the wheels and torque 100 ft lbs, drive for about 20 miles and then remov the wheels and retorque the spacers to 100 ft lbs, a few nuts will snug up. Then reinstall the wheels and torque to 100 ft lbs. Drive for 20 miles and retorque the wheels to 100 ft lbs. Now its officially installed. *note: hour application may require more or less ft lb torque, refer to owner's manual or certified technician for appropriate torque.

50181–50200 of 60,823 reviews