42025-01-22

Worked on my 2029 Malibu . Put older impala rims on for winter tires ,they gave the right amount of clearance .<br>Almost two week and no issues!!<br>Price is a little bit higher then others only reason why I gave it a 4

52025-01-21

I purchased these for my 1997 Jeep Cherokee XJ. I run a high pinion Dana 30 and a Chrysler 8.25 rear. Stock I have 3/4” of stud showing on both axles. I was able to get about 7/16” of the new nut over the stud with spacer in place. I wish it was more but I think they will work. Haven’t run them on the car yet. My old Dana 35 axle also shows 3/4” stud so it should work on that axle too.

52025-01-21

These spacer make the factory wheels look really good by letting the wheel/tires sit where they should instead of looking sucked into the side of the vehicle. I use these on most of my vehicles with factory wheels I've put over 30k miles on a set with no issues.

52025-01-21

Fit great and are the correct width. Installed on 2001 mustang

52025-01-21

Used these to widen out the stance of my rear tires on a Kubota BX. Doesn’t feel near as tippy, did their job all that needs said.

52025-01-21

It's pricy but worth it to get the original equipment design. Converted exhaust gases efficiently with no issues.

52025-01-21

They fit my 350z perfect and I didnt need new lugs. They're a bit on the cheaper side so I would get massive vibrations at speeds above 70mph. I went ahead and had them balanced with my rims and torqued down to 100ftlbs on my hub before mounting my rims. I never had another issue since. Watch out tho! ALL wheel spacers will add premature wear on your wheel bearings.

42025-01-20

Works well, no issues. Customer service was really helpful when I had a question.

42025-01-20

Delivery was faster than I thought it would be. The converter is in and my car's running smoothly. Two thumbs up!

52025-01-20

Spacers went on with no fuss and really cleaned up the wheels. Good instructions included. Happy so far for the low cost.